This cover has two side windows with a zippered double metal handle that allows proper ventilation avoiding condensation and problems of humidity, mold, etc.
The design also includes the transparent roof, a fundamental aspect if your camper has solar panels or you plan to install them in the future. It is an essential element so as not to compromise the charge of the batteries with the cover installed.
It also includes 2 staves of 2.50 meters each, with sewn velcro, to fasten the base of the roof cover to the original guides of the vehicle. If your camper has an awning installed, you will only have to cut one of the staves to the necessary size.
In case of not having guides, the roof cover can be fixed with ropes, rubber bands, suction cups or magnets (not included) in the multiple eyelets located on the lower perimeter.
Dimensions of the rolled product in its transport bag: 60x20x10 cm approx.
It is essential to start the mounting of the cover at the front of the roof by slightly raising the roof of the vehicle and fitting the two front corners of the cover.
Next, stretch the cover towards the rear of the vehicle and insert the two strings into the side guides. Raise the ceiling halfway, join the Velcro on the base of the cover with those on the strings, and finally finish raising the ceiling to its highest position.
If you have a side awning, you can cut 2 pieces of staff to size to place in the free guide sections that are in front of and behind the awning. In any case, the lower perimeter of the cover has several metal eyelets in case you prefer to hold it with elastic bands, ropes, magnets or suction cups (not supplied).
The cover is made of Oxford nylon fabric, waterproofed on both sides, with anti-UV treatment, reinforced and heat-sealed seams on the inside. It is a strong and light material, absolutely waterproof, highly resistant to wind, blows and tears.