Coolant return hose from the front heater matrix VW T3 petrol or Diesel, 3.90 mts
Ø inner: 15 mm.
Ø outer: 23 mm.
Length: approximately 3,90 meters.
It runs from the curved return hose over the front heater matrix to the rear of the engine.
This hose will need to be shortened if necessary depending on the engine type.
As a guide (this is not an exact science for these models, and it is necessary to measure carefully before cutting):
- A WBX petrol engine manufactured before 07/1985 with the "old" cooling system will require shortening the hose to approximately 3.53 meters.
- A WBX petrol engine manufactured after 07/1985 with the "modern" cooling system will require shortening the hose to approximately 3.82 meters.
- A Diesel engine will require shortening the hose to approximately 3.53 meters.
- If the van has an auxiliary heater in the passenger compartment under the rear bed seat, it will need to be cut to the desired length where the "T" connector that branches off to the heater is located.
By buying this product you can collect up to 4 loyalty points. Your cart will total 7 points that can be converted in future orders into a voucher of €1.05.
You might also like
